Home About Us Products Servers Contact  



You are in Industrial Automation > Industrial PC Chassis

IPC-622
20-slot Fault-resilient IPC Chassis

IPC-622 Introduction

The IPC-622 is a high-end 20-slot, 19" rackmount industrial PC chassis with a 300-watt hot-swappable redundant power supply. Up to six disk drives can be installed into the IPC-622. This unit supports up to four front accessible, half-height storage devices. The IPC-622 can support up to four PC systems in a single chassis which is perfect for space-critical applications. Moreover, the IPC-622 features an advanced fault detection and alarm notification feature. The IPC-622 monitors its own hardware status including power failure, fan failure and temperature. When malfunctions occur, an audible alarm will be activated that alerts the user of maintenance needs. Problems can be clearly identified through the IPC-622's front panel LED.

Multi-system Configuration
Versatile 20-slot ISA/PCI backplanes are available for the IPC-622 to hold one, two or four independent PC systems in a single chassis. Customized backplanes are available through our OEM/ODM program. The IPC-622's front control panel can support up to four CPU reset buttons and four DIN-5P keyboard ports for each individual system in the unit.

Hot-Swappable Redundant Power Supply
The IPC-622 comes with a 300-watt hot-swappable redundant power supply which increases the system's reliability and extends the system's life time.

Zero Down Time
This power supply unit is composed of two 300-watt independent power modules which share the system's load during normal operation. If one fails, the other will take the full load automatically without disturbing the system's operation. An audible alarm and visible LED will alert the user of system malfunctions.

Easy Maintenance
Maintaining the hot-swappable power supply is simple. Just unplug the bad power module and plug in a good one, all without turning off the main power during replacement.

Fault Detection and Alarm Notification
The IPC-622's fault-detection system will continuously monitor the computer for power failure, fan failure and/or high temperature. Fault conditions are as follows:

  • Power failure: If any power modules fail
  • Fan failure: If any of the four cooling fans fail
  • Excess temp: If the chassis internal temperature exceeds 65 C (149 F)


When a fault is detected, an audible alarm will sound to alert the user. The corresponding LED indicator (located on the front panel) will change color from green to red.


IPC-622 Features

  • 19" rackmount, rugged chassis
  • 20-slot passive backplane providing up to four computer systems
  • Four high-speed cooling fans maintaining optimal air ventilation
  • Two front-removable air filters
  • Drive bays accommodate up to 8 front accessible drives
  • Up to two 350-watt UL redundant power supplies
  • Four sets of control switches, keyboard connectors and status indicators


IPC-622 Specification

General Specifications
  • Construction: Heavy-duty steel chassis
  • Disk Drives: Supports four front-accessible, half-height drives. Vibration-damped with mounting holes for an extra two 3.5" HDDs inside
  • Cooling fans: Four 49 CFM, front-mounted cooling fans (flow-in) with air filters
  • Controls: Power On/Off switch, CPU reset button and alarm reset button. Protected by a lockable door
  • Status indicators: Eight LEDs for +5 V, +12 V, -5 V, -12 V, HDD activity, power failure, fan failure and excess temperature
  • Keyboard connector: Pre-wired 5-pin DIN connectors on both front and rear panels
  • Speaker: One 8-ohm speaker
  • Dimensions (W x H x D): 482 x 267 x 457 mm (19" x 10.5" x 18")
  • Net weight: 30 kg (66 lbs)
  • Paint color: PANTONE 415C
Fault Detection and Alarm Notification
  • Power failure: If either power module fails, an LED alarm indicator will change color from green to red
  • Fan failure: If any of the four cooling fans fail, an alarm indicator LED will change color from green to red
  • Excess temperature: If the interior temperature exceeds 65 C (149 F), the LED alarm indicator changes color from green to red. It remains red until the temperature falls below 60 C
  • Audible alarm: An alarm sounds to indicate malfunction. It remains on until the reset button is pressed. However, the LED light will remain red until the problem is resolved
Redundant Power Supply (RPS-300)
  • Output rating: 300 W (max.)
  • Input voltage: 90 ~ 132 VAC or 180 ~ 264 VAC @ 47 ~ 63 Hz, switchable
  • Audible alarm: +5 V @ 30 A, +12 V @ 12 A, -5 V @ 0.5 A, -12 V @ 0.5 A (min. load +5 V @ 3 A, +12 @ 1 A is needed)
  • Safety: UL/CSA/TV approved
  • MTBF: 100,000 hrs @ 70% load
Passive Backplane (PCA-6120)
  • Slots: 20 slot, ISA-bus for full-size cards
  • Segments: One
  • PC board: 4-layer PCB with ground and power planes for reduced noise and lower impedance
  • Indicators: LEDs for +5 V, -5 V, +12 V and -12 V
Passive Backplane (PCA-6120D)
  • Indicators: LEDs for +5 V, -5 V, +12 V and -12 V
  • Slots: 20-slot, ISA-bus for full-size cards
  • Segments: Two, 10-10
  • PC board: 4-layer PCB with ground and power planes for reduced noise and lower impedance
Passive Backplane (PCA-6120Q)
  • Slots: 20-slot, ISA-bus for full-size cards
  • Segments: Four, 5-5-5-5
  • PC board: 4-layer PCB with ground and power planes for reduced noise and lower impedance
  • Indicators: LEDs for +5 V, -5 V, +12 V and -12 V
Passive Backplane (PCA-6120P4)
  • Slots: 15 ISA / 4 PCI / 1 PICMG slots for full-size cards
  • Segments: One
  • PC board: 4-layer PCB with ground and power planes for reduced noise and lower impedance
  • Indicators: LEDs for +5 V, -5 V, +12 V and -12 V
Mechanical and Environmental Specifications
  • Operating temperature: 0 ~ 50 C (32 ~ 122 F)
  • Relative humidity: 10 ~ 95% @ 40 C, non-condensing
  • Vibration (operation): 5 ~ 17 Hz, 0.1" double amplitude displacement; 17 ~ 500 Hz, 1.5 G acceleration
  • Shock (operation): 10 G acceleration peak (11 msec. duration)
  • Safety: UL approved
  • EMI: Meets FCC/VDE Class A
  • CE compliant

IPC-622 Ordering Information

  • IPC-622-300R : 20 ISA slots, single segment
  • IPC-622D-300R : 10-10 ISA slots, dual segments
  • IPC-622Q-300R : 5-5-5-5 ISA slots, quad segments
  • IPC-622P-300R : 15 ISA / 4 PCI / 1 PICMG slots, single segment
  • IPC-622DP-300R : 2 x (4 ISA / 4 PCI / 1 PICMG) slots, dual segments
  • IPC-622-30048R : 20 ISA slots, single segment
  • IPC-622D-30048R : 10-10 ISA slots, dual segments
  • IPC-622Q-30048R : 5-5-5-5 ISA slots, quad segments
  • IPC-622P-30048R : 15 ISA / 4 PCI / 1 PICMG slots, single segment
  • IPC-622DP-30048R : 2 x (4 ISA / 4 PCI / 1 PICMG) slots, dual segments
  • RPM-300 : Spare 300 W power module for RPS-300
  • RPM-30048 : Spare 300 W power module for RPS-30


IPC-622
Click image to enlarge

Get Price
Download PDF




 

Copyright UCS.co.uk 1997-2013. UCS is a trading name of Lilliput UK Ltd. Lilliput UK Ltd also operates: Car Computer, Cabcast

B Server